Everything is assembled and wired up on the X and Y axes.
Meanwhile, The Shiz sits quietly, watching proceedings....
Just to prove it's actually running:
There. Next, limit switches and then the Z axis!
Friday, 11 January 2019
Subscribe to:
Post Comments (Atom)
Getting an ESP32-S3-Mini to talk to an HX711 load cell amplifier and the Bojke laser distance sensor
It's all very well using that large DIN Rail-mounted ESP32-S3-POE-ETH-8DI-8DO to talk to the laser sensor and load cell but it feels a b...
-
Setting up the servo tuning(?) software: Having spent a couple of hours yesterday pratting about with the PID controllers for the X and Z ax... -
Right, so having gone through the motions with the X axis (cross slide), I should now be able to set up the Z axis (longitudinal) encoder an... -
The bearing arrived as expected this morning. Took a few minutes to make up a 42 x 25.5 x 7mm thrust washer, then fitted the bearing and was...
No comments:
Post a Comment