36mm through bore:
Fixing slots spaced to suit the table of The Shiz
Chuck at top front of box, to minimise intrusion into the machine space
4th axis - done.
TFFT. Now I guess I'll have to mount it on the machine and try it out.
Friday, 7 August 2020
4th axis - finally completed
Finally all assembled and all machine screws fitted. No cockups or fettling required.
36mm through bore:
Fixing slots spaced to suit the table of The Shiz
Chuck at top front of box, to minimise intrusion into the machine space
4th axis - done.
TFFT. Now I guess I'll have to mount it on the machine and try it out.
36mm through bore:
Fixing slots spaced to suit the table of The Shiz
Chuck at top front of box, to minimise intrusion into the machine space
4th axis - done.
TFFT. Now I guess I'll have to mount it on the machine and try it out.
Subscribe to:
Post Comments (Atom)
Getting an ESP32-S3-Mini to talk to an HX711 load cell amplifier and the Bojke laser distance sensor
It's all very well using that large DIN Rail-mounted ESP32-S3-POE-ETH-8DI-8DO to talk to the laser sensor and load cell but it feels a b...
-
Setting up the servo tuning(?) software: Having spent a couple of hours yesterday pratting about with the PID controllers for the X and Z ax... -
Right, so having gone through the motions with the X axis (cross slide), I should now be able to set up the Z axis (longitudinal) encoder an... -
The bearing arrived as expected this morning. Took a few minutes to make up a 42 x 25.5 x 7mm thrust washer, then fitted the bearing and was...
No comments:
Post a Comment