Everything is assembled and wired up on the X and Y axes.
Meanwhile, The Shiz sits quietly, watching proceedings....
Just to prove it's actually running:
There. Next, limit switches and then the Z axis!
Friday, 11 January 2019
Subscribe to:
Post Comments (Atom)
Canvas upgrade for the Elegoo Centauri Carbon 3D printer?
All these different names are a bit confusing. The "Centauri" is the open frame version The "Centauri Carbon" version in...
-
Setting up the servo tuning(?) software: Having spent a couple of hours yesterday pratting about with the PID controllers for the X and Z ax... -
Right, so having gone through the motions with the X axis (cross slide), I should now be able to set up the Z axis (longitudinal) encoder an... -
WTF? This must the the definitive rabbit hole. I've been aiming to attempt a modification to the existing post processor that is provid...
No comments:
Post a Comment