36mm through bore:
Fixing slots spaced to suit the table of The Shiz
Chuck at top front of box, to minimise intrusion into the machine space
4th axis - done.
TFFT. Now I guess I'll have to mount it on the machine and try it out.
Friday, 7 August 2020
4th axis - finally completed
Finally all assembled and all machine screws fitted. No cockups or fettling required.
36mm through bore:
Fixing slots spaced to suit the table of The Shiz
Chuck at top front of box, to minimise intrusion into the machine space
4th axis - done.
TFFT. Now I guess I'll have to mount it on the machine and try it out.
36mm through bore:
Fixing slots spaced to suit the table of The Shiz
Chuck at top front of box, to minimise intrusion into the machine space
4th axis - done.
TFFT. Now I guess I'll have to mount it on the machine and try it out.
Subscribe to:
Post Comments (Atom)
Get those tube bender brackets finished!
Last time, I'd drilled and bored out the brackets for the bearing and ballnut. To complete these parts and approach the point of assembl...
-
Setting up the servo tuning(?) software: Having spent a couple of hours yesterday pratting about with the PID controllers for the X and Z ax... -
Right, so having gone through the motions with the X axis (cross slide), I should now be able to set up the Z axis (longitudinal) encoder an... -
WTF? This must the the definitive rabbit hole. I've been aiming to attempt a modification to the existing post processor that is provid...
No comments:
Post a Comment