Subscribe to:
Post Comments (Atom)
Get those tube bender brackets finished!
Last time, I'd drilled and bored out the brackets for the bearing and ballnut. To complete these parts and approach the point of assembl...
-
Setting up the servo tuning(?) software: Having spent a couple of hours yesterday pratting about with the PID controllers for the X and Z ax... -
Right, so having gone through the motions with the X axis (cross slide), I should now be able to set up the Z axis (longitudinal) encoder an... -
WTF? This must the the definitive rabbit hole. I've been aiming to attempt a modification to the existing post processor that is provid...
No comments:
Post a Comment