Seems to fit nicely:
Cool. Now to prepare for the "top side" machining.
Thursday, 5 October 2017
Soft jaws made
Here's the CAM toolpath for the soft jaws. I've moved the WCS origin to the top front left so that any error in the depth of the jaws don't affect the dimensions.
Setting the WCS origin with Z=7.5mm (in G53), using the knee to position the height of the stock. The gap between the jaws needs to be 83mm. I used one of the hard jaws and some ground parallels to achieve 83.3mm.
Here it is after machining:
Seems to fit nicely:
Underside view:
Cool. Now to prepare for the "top side" machining.
Seems to fit nicely:
Cool. Now to prepare for the "top side" machining.
Subscribe to:
Post Comments (Atom)
Machining the ballnut bracket using Probe Basic Lathe conversational
I cut the stock to size previously, so just need to centre it in the 4-jaw and drill the 25.5mm pilot drill ahead of sending the boring bar ...
-
Setting up the servo tuning(?) software: Having spent a couple of hours yesterday pratting about with the PID controllers for the X and Z ax... -
Right, so having gone through the motions with the X axis (cross slide), I should now be able to set up the Z axis (longitudinal) encoder an... -
WTF? This must the the definitive rabbit hole. I've been aiming to attempt a modification to the existing post processor that is provid...
No comments:
Post a Comment