Lucas Is Busy
Subscribe to:
Post Comments (Atom)
Butchering the chip tray - mounting the drag chain tower
The drag chain tower (aka the base for the fixed end of the drag chain) is a fairly simple concept - a lid holds the chain in place, as well...
-
Setting up the servo tuning(?) software: Having spent a couple of hours yesterday pratting about with the PID controllers for the X and Z ax... -
Right, so having gone through the motions with the X axis (cross slide), I should now be able to set up the Z axis (longitudinal) encoder an... -
The bearing arrived as expected this morning. Took a few minutes to make up a 42 x 25.5 x 7mm thrust washer, then fitted the bearing and was...
No comments:
Post a Comment