These are the holes required:
Top:
- VFD conduit
- Mains inlet
- Probe connection
- 4th axis connection
- PC / Ethernet connections
Bottom:
- X, Y & Z axis motors
- X & Y limit switches
- Coolant and lube pump
Saturday, 10 March 2018
Cabinet fettling.
Need to make holes for all the cable entries, switch / display / air inlet etc. Not the most enjoyable part, as it's a steel box. The big holes will be challenging....
These are the holes required:
Top:
These are the holes required:
Top:
Subscribe to:
Post Comments (Atom)
Get those tube bender brackets finished!
Last time, I'd drilled and bored out the brackets for the bearing and ballnut. To complete these parts and approach the point of assembl...
-
Setting up the servo tuning(?) software: Having spent a couple of hours yesterday pratting about with the PID controllers for the X and Z ax... -
Right, so having gone through the motions with the X axis (cross slide), I should now be able to set up the Z axis (longitudinal) encoder an... -
WTF? This must the the definitive rabbit hole. I've been aiming to attempt a modification to the existing post processor that is provid...
No comments:
Post a Comment